TGB Blade 250 ATV Quad Service Repair Manual, Page 9Get this manual

TGB Blade 250 ATV Quad Service Repair Manual, Page 9

1GENERAL INFORMATION The length of bolts and screws for assemblies, cover plates or boxes is different from one another,
tool first diagonally from inside toward outside, important components should be tightened to times with appropriate increments
to avoid warp unless otherwise indicatedBolts and fasteners should be kept clean and dryDo not apply oil to the threads Rubber
and plastic boots should be properly reinstalled to the original correct positions as designed When oil seal is installed,
fill the groove with grease, install the oil seal with the name of the manufacturer facing outside, and check the shaft on
which the oil seal is to be installed for smoothness and for burrs that may damage the oil sealManufacturer's name The tool
should be pressed against two (inner and outer) bearing races when removing ball bearingDamage may result if the tool is
pressed against only one race (either inner race or outer race)In this case, the bearing should be replacedTo avoid damaging