2000 Arctic Cat ATV Factory Service Manual, Page 12Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 12

Break-In Procedure A new ATV and an overhauled ATV engine require "break-in" periodThe first 10 hours (or 200 miles) are
however, brief full-throttle accelerations and variations in driving speeds contribute to good engine break-inDuring the
break-in period (or whenever the brake pads are replaced), the hydraulic brake pads must be burnishedSlow disc-speed hydraulic
brakes must be properly burnished in order to achieve maximum stopping power ! WARNING Do not attempt sudden stops or put
the ATV into situation where sudden stop will be required until the brake pads are properly burnishedNOTE: Do not be reluctant
to heat up the brake pads during the burnishing procedure After the completion of the break-in period, the engine oil and
oil filter should be changedOther maintenance after break-in should include checking of all prescribed adjustments and tightening
of all fasteners Gasoline-Oil-Lubricant RECOMMENDED GASOLINE The recommended gasoline to use in this ATV is 87 minimum octane