2000 Arctic Cat ATV Factory Service Manual, Page 34Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 34

6Apply oil to the O-ring and check to make sure it is positioned correctly; then install the new oil filterTighten securelyNOTE:
the engine (while the ATV is outside on level ground) and allow it to idle for few minutes10Turn the engine off and wait
approximately one minuteRecheck the oil level in the engine oil inspection windowThe oil level should be visible through
the windowIf oil is not visible, add recommended oil until the oil level is visible between the lines of the windowFig2-67
NOTE: To service oil strainer, see Section 3 4Place the oil strainer into position beneath the crankcase and secure with
the Phillips-head cap screwsFig2-70 ATV-0074 11Inspect the area around the drain plug and oil filter for leaksSTRAINER To
check the oil strainer, use the following procedureCC163D 1Remove the skid plate2Remove the cap screws securing the oil strainer