2000 Arctic Cat ATV Factory Service Manual, Page 39Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 39

HEADLIGHT CHECKINGADJUSTING HEADLIGHT AIM To replace the headlight bulb, use the following procedure ! CAUTION The bulb portion
obtained in step 2, make horizontal marks on the aiming surface4Make vertical marks which intersect the horizontal marks
on the aiming surface directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW
BEAM6Observe each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below
the horizontal mark on the aiming surfaceFig2-84 2Push in on the wiring harness socket and turn it counterclockwise to free
the bulb; then remove the bulb3Place the new bulb into position making sure the tab on the bulb base aligns with the recess
in the housing4Install the wiring harness socket making sure the tab in the socket aligns with its recessTurn clockwise to
lock socket in placeNOTE: If wiring harness slack was established for removing the socket, carefully pull the wiring harness
back through the housing 5Place the headlight into the housing and install the lens cover6Install the machine screw and tighten