2000 Arctic Cat ATV Factory Service Manual, Page 42Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 42

CRemove the protective cap, install one end of clear hose onto one FRONT bleeder screw, and direct the other end into container;
Brake Fluid (pn 0638-315)Fig2-91 AF739DA AF769D BInstall and secure the cover; then slowly compress the brake lever several
timesFig2-92 NOTE: During the bleeding procedure, watch the master cylinder reservoir very closely to make sure there is
always sufficient amount of brake fluidIf the fluid level gets below the bottom line on the reservoir, refill the reservoir
before the bleeding procedure is continued DRepeat step until the brake lever is firmEAt this point, perform step B, C, and
on the other FRONT bleeder screw; then move to the REAR bleeder screw and follow the same procedure 4Carefully check the