2000 Arctic Cat ATV Factory Service Manual, Page 43Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 43

! CAUTION This hydraulic brake system is designed to use high-temperature D.O.T3 brake fluid onlyIf brake fluid must be added,
they show excessive wearCheck the thickness of each of the brake pads as follows1Remove front wheel2Measure the thickness
of each brake padFig2-95 EInstall the wheelTighten cap screws to 6.9 kg-m (50 ft-lb) 5Burnish the brake pads (see Burnishing
Brake Pads in this section) AF739DB Mechanical Foot Brake CHECKING 3If thickness of either brake pad is less than 3.2 mm
(0.125 in, the brake pads must be replacedNOTE: The brake pads should be replaced as set 4To replace the brake pads, use
the following procedureARemove the wheelBRemove the cap screws securing the caliper to the bracket; then remove the cotter
pin securing the pads and remove the pads Although the rear brake has been adjusted at the factory, the brake should be checked
for proper operationThe mechanical brake must be maintained to be fully functional1With the engine off, transmission in neutral,and