2000 Arctic Cat ATV Factory Service Manual, Page 65Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 65

20Pour 3.3 (3.5 U.Sqt) of recommended oil into the enginetransmission filler hole; install the filler plugFig3-89 14Route
inside the frame and connect to the muffler at the junctureNOTE: If the muffler was removed, see Section 8 22Connect all
remaining electrical connections; then install the battery making sure to connect the positive battery cable first and the
negative cable last23Install the seat making sure it "locks" into position 17Place the exhaust pipe header with new grafoil
gasket into position on the cylinder head; install and tighten the cap screws to 2.8 kg-m (20 ft-lb)18Install the front fenders
and the front rack (see Section 8)19Install the gas tank (see Section 4) ! CAUTION If the engine had major overhaul or if