2000 Arctic Cat ATV Factory Service Manual, Page 70Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 70

Fig3-111 Fig3-112 ATV-1085 AStarting with the top ring, slide one end of the ring out of the ring-grooveBRemove each ring
rubber washers on the top side cap screwsRemove the valve coverAccount for and note the orientation of the cylinder head
plugNote the location of two alignment pinsFig3-113 AT THIS POINT To service center crankcase components only, proceed to
Removing Left-Side Components Removing Top-Side Components (400500 cc) AValve Cover BCylinder Head NOTE: Remove the spark
plug and timing inspection plug; then using the recoil starter, rotate the ra nk haft to top-dead-center of the compression