2000 Arctic Cat ATV Factory Service Manual, Page 75Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 75

2Place the valve cover on the Surface Plate (pn 0644-016) covered with #400 grit wet-or-dry sandpaperUsing light pressure,
the original location of each valve set for use during installationReturn each valve set to its original location during
installation 1Using valve spring compressor, compress the valve springs and remove the valve cottersAccount for an upper
spring retainerFig3-137 ! CAUTION Do not remove an excessive amount of the sealing surface or damage to the camshaft will
resultAlways check camshaft clearance when resurfacing the valve coverFig3-135 Fig3-138 Fig3-136 2Remove the valve seal and