2000 Arctic Cat ATV Factory Service Manual, Page 84Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 84

Fig3-208 Fig3-210 NOTE: At this point, oil the camshaft bearings, cam lobes, and the three seating journals on the cylinder
down (toward the piston)CCamshaft alignment marks parallel to the valve cover mating surfaceDRecessed side of the sprocket
directed toward the cam lobesECamshaft alignment pin and sprocket alignment hole (smallest) are aligned NOTE: Note the position
of the alignment marks on the end of the camshaftThey must be parallel with the valve cover mating surfaceIf rotating the
camshaft is necessary for alignment, do not allow the chain and sprocket to rotate and be sure the cam lobes end up in the
down position ! CAUTION If any of the above factors are not as stated, go back to step 13 and carefully proceed 15Place the