2000 Arctic Cat ATV Factory Service Manual, Page 94Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 94

Fig3-254 30Adjust valvetappet clearance using the following procedureNOTE: Use Valve Clearance Adjuster (pn 0444-078) for
counterclockwise until proper valvetappet clearance is attainedNOTE: Refer to the appropriate Specifications for the proper
valvetappet clearanceN OTth valve adjust di counterclockwise will open the valvetappet clearance by 0.05 mm (0.002 in per
mark 27Place the valve cover into positionNOTE: At this point, the rocker arms and adjuster screws must not have pressure
on them FWhile holding the adjuster dial at the proper clearance setting, tighten the jam nut securely with the valve adjuster
handle31Place the two tappet covers into position making sure the proper cap screws are with the proper coverTighten the
cap screws securelyFig3-257 28Install the four top side cap screws with rubber washers; then install the remaining cap screwsTighten
only until snugFig3-256 32If removed, install the spark plugCC003D 29In crisscross pattern starting from the center and working