2000 Arctic Cat ATV Factory Service Manual, Page 111Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 111

Fig3-347 Fig3-350 6Install the ratchet making sure the end is properly installed on the reelFig3-348 9While pushing down
release the rope from the notch and allow the rope to retract12Pull the rope out two or three times to check for correct
tensionNOTE: Increasing the rotations in step 11 will increase spring tension 13Place the gasket and recoil starter assembly
into position on the left-side cover noting the location of the single washer; then tighten the cap screws to 0.8 kg-m (6