2000 Arctic Cat ATV Factory Service Manual, Page 125Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 125

Fig3-419 Fig3-422 18Place thrust washer onto the crankshaft; then install the starter clutch gear assembly onto the crankshaftPlace
Assembly FRecoil Starter NOTE: Steps 1-20 in the preceding sub-section must precede this procedure 21Place the gasket and
left-side cover into position on the crankcaseCC332D 19Place the magneto rotor into position on the crankshaft; then install
the magneto nut on the crankshaft and tighten until the rotor is properly seatedTighten to 16 kg-m (115.5 ft-lb) NOTE: It