2000 Arctic Cat ATV Factory Service Manual, Page 127Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 127

27Pull up on the HiLow shift T-handle and guide the T-handle stop pin into the Hi range lever stop plate slot; then slide
components may be necessaryNote the AT THIS POINT information in each sub-sectionCC044D NOTE: The enginetransmission does
not have to be removed from the frame for this procedure 28Place the starter cup into position on the crankshaft making sure
new, lubricated O-ring is inside the cupTighten the flange nut to 3.5 kg-m (25 ft-lb)Fig3-431 Removing Right-Side Components
(250300 cc) ACover BRelease Roller Guide 29Place the gasket and recoil starter assembly into position on the left-side cover;
then tighten four cap screws to 0.8 kg-m (6 ft-lb)Fig3-432 1Turn the gas tank valve to the OFF position and lay the ATV on