2000 Arctic Cat ATV Factory Service Manual, Page 150Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 150

Fig3-542 24Place the gasket and right-side cover into position making sure the release roller guide remains correctly positioned
the cap screws in crisscross pattern to 0.9-1.3 kg-m (6.5-9.5 ft-lb)26Place the water pump cover onto the right-side cover
making sure the new O-ring is properly positionedTighten with the three cap screws to kg-m (7 ft-lb)Fig3-546 23Place the
water pump drive joint into position on the water pump shaft making sure the pin is properly positionedFig3-543 NOTE: Care