2000 Arctic Cat ATV Factory Service Manual, Page 161Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 161

Fig3-600 CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting
the indicator and push the small end of the connecting rod away from the dial indicator3Maximum deflection is mm (0.12 inMeasuring
Connecting Rod (Big End Side-to-Side) 1If tooth contact pattern is comparable to an incorrect pattern, correct tooth contact
according to the following chartTooth Contact Contacts at Top Contacts at Root Shim Correction Decrease Shim Thickness Increase
Shim Thickness 1Push the lower end of the connecting rod to one side of the crankshaft journal2Using feeler gauge, measure
the gap between the connecting rod and crankshaft journal NOTE: To correct tooth contact, steps and (with NOTE) of "Correcting
Backlash" must be followed and the above "Tooth ContactShim Correction" chart must be consulted ! CAUTION After correcting