2000 Arctic Cat ATV Factory Service Manual, Page 175Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 175

Inspecting Fig3-672 1Inspect the gear, pins, and keyway for wear2Inspect the springs for damage or fatigueAssembling 1Align
assembled for installation Assembling Crankcase Half (250300 cc) 3Using pair of needle-nose pliers, insert each remaining
spring part way into the slot; then install pin and push the springpin assembly into the slot NOTE: For ease of assembly,
install components on the right-side crankcase halfNOTE: If the output shaft was removed, make sure that the proper shim
is installed 1Place the oil pipe in position and secure to the crankcase with the Phillips-head screws coated with red Loctite