2000 Arctic Cat ATV Factory Service Manual, Page 180Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 180

Fig3-697 NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs + AT THIS POINT After completing
left-side crankcase halfNOTE: If the output shaft was removed, make sure that the proper shim is installed 1To install the
output shaft, place the shaft into position with proper shims, slide the gear onto the shaft, and secure with new nut tightened
to 10 kg-m (72.5 ft-lb)Fig3-700 Fig3-699 Fig3-701 5In crisscrosscase-to-case pattern, tighten the mm cap screws until the
halves are correctly joined; then tighten to 2-2.4 kg-m (14.5-17.5 ft-lb)NOTE: Rotate the shafts back and forth to ensure