2000 Arctic Cat ATV Factory Service Manual, Page 183Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 183

Fig3-714 Fig3-716 10Install the two gear shift fork shafts; then verify that the two crankcase half alignment pins are in
on the idler shaft; then apply Three Bond Sealant (pn 0636-070) to the mating surfacesPlace the right-side half onto the
left-side half 2Using plastic mallet, lightly tap the case halves together until cap screws can be installed3From the left
side, install the three case half mm cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to ensure