2000 Arctic Cat ATV Factory Service Manual, Page 184Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 184

Fig3-719 6From the right side, install the five case half mm cap screws (one inside the case); then tighten only until snugNOTE:
are correctly joined; then tighten to 2-2.4 kg-m (14.5-17.5 ft-lb)NOTE: Rotate the shafts back and forth to ensure no binding
or sticking occurs 8In crisscrosscase-to-case pattern, tighten the mm cap screws to 0.9-1.3 kg-m (6.5-9.5 ft-lb)NOTE: Rotate
the shafts back and forth to ensure no binding or sticking occursCC097D + AT THIS POINT After completing center crankcase
components, proceed to Installing Right-Side Components, to Installing Left- Side om ponents,and to Installing Top-Side Components