2000 Arctic Cat ATV Factory Service Manual, Page 208Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 208

1Drain the coolant2Remove the three cap screws securing the water pump caseNote the position of the long cap screw and account
damaged, they must be replaced as set 3Inspect the impeller for corrosion or damageASSEMBLINGINSTALLING WATER PUMP NOTE:
Treat seals and O-rings with clean antifreeze for initial lubricationAF642D REMOVINGDISASSEMBLING WATER PUMP KEY 1Case 2Cap
Screw 3Gasket 4O-Ring 5Cap Screw 6Cap Screw 7Joint 8Shaft wBearing 9Pin 10Pump Drive Seal 11Mechanical Seal 12Impeller 13Cap
Screw 14Washer 15Gasket 1Press the mechanical seal with pump drive seal into the impeller by hand2Install the mechanical
seal assembly onto the water pump shaft and secure with the cap screw, washer, and gasketTighten the cap screw to 1.05 kg-m
(7.5 ft-lb)3Place the water pump case into position and secure with the three cap screwsNote the position of the long cap
screw from removal4Fill the cooling system (2.9 or U.Sqt) with antifreezeNOTE: While the cooling system is being filled,