2000 Arctic Cat ATV Factory Service Manual, Page 211Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 211

NOTE: Electrolyte should be at room temperature before fillingDo not use water or any other liquid to activate battery RPM
WATER as necessary; then install the vent plugsWash off acid spillage with water and dry the battery 1Ensure that the throttle
cable is adjusted correctly at 3-6 mm (18-14 in free-play at the leverFig5-1 ! CAUTION Before installing the battery, make
sure the ignition switch is in the OFF position 6Place the battery into position in the ATV and secure7Connect cables to
the proper terminals: positive cable to the positive terminal (+) and negative cable to the negative terminal (-)Connect
the negative cable lastATV-0047 ! CAUTION Connecting cables in reverse (positive to negative and negative to positive) can
cause serious damage to the electrical system 2Loosen the jam nut of the limiter screw and rotate the screw clockwise until
RPM is limited to under 9000 RPM (250300 cc) or under 8300 RPM (400500 cc); then tighten the jam nutFig5-2 8Check the vent