2000 Arctic Cat ATV Factory Service Manual, Page 213Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 213

NOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, switch, or the main wiring harnessNOTE: If the
switch, or the main wiring harnessNOTE: If the meter shows battery voltage, the in iring harness is good; test the switchcomponent,
the connector, and the switch wiring harness for resistanceRESISTANCE (Brakelight Switch Connector) 3When the brake pedal
is depressed, the meter must show less than ohmNOTE: If the meter shows more than ohm of istancetroubleshoot or replace the
switchcomponent, the connector, or the switch wiring harness ! CAUTION Always disconnect the battery when performing resistance
tests to avoid damaging the multimeterNOTE: The brake lever must be compressed for this testAlso, the ignition switch must
be in the OFF position Brakelight Switch (Handlebar Control) The switch connector is the two-prong black connector in front
of the steering postTo access the connector, the front rack and front fenders must be removed (see Section 8)NOTE: The ignition