2000 Arctic Cat ATV Factory Service Manual, Page 216Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 216

NOTE: Battery voltage will be indicated from only one side of the fuse holder connector terminal; the other side will show
the red tester lead to one spade end of the fuse; connect the black tester lead to the other spade endFig5-14 NOTE: Refer
to Fig5-15 when testing the gear position lights To access the gear position light connector for testing purposes, use the
following procedure1Remove the three machine screws and key cover securing the instrument pod2Remove the light bar from the
instrument pod; then cut the cable tie securing the instrument pod wiring to the steering post3Push the instrument pod wiring
with light bar downward to access the gear position light connector; then disconnect the connector from the main wiring harnessNOTE:
For testing purposes, the Indicator Lights connector must also be disconnected to access the power source terminal 3The meter