2000 Arctic Cat ATV Factory Service Manual, Page 217Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 217

Fig5-16 High Beam Power Source Reverse 3The fourth gear position indicator light should illuminateFIFTH GEAR 1Connect the
pod wiring to the steering post using cable tie 1Connect the jumper positive wire to the power source terminal on the indicator
light connector2Connect the jumper ground wire to the first gear terminal on the gear position light connector3The first
gear position indicator light should illuminateSECOND GEAR Gear Position Switch (300400500 cc) 1Connect the jumper positive
wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the second gear terminal
on the gear position light connector3The second gear position indicator light should illuminateTHIRD GEAR NOTE: The ignition
switch must be in the OFF positionAlso, the tests should be made at the white connector directly behind the reverse leverTest
the lower end of the connector (coming from the switch) 1Connect the jumper positive wire to the power source terminal on
the indicator light connector2Connect the jumper ground wire to the third gear terminal on the gear position light connector3The