2000 Arctic Cat ATV Factory Service Manual, Page 218Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 218

FIRST GEAR 1Set the meter selector to the D.CVoltage position2Connect the black tester lead to the whiteblue wire; connect
meter must show less than ohmFOURTH GEAR ! CAUTION Always disconnect the battery when performing resistance tests to avoid
damaging the multimeterNOTE: For these tests, the meter selector should be set to the OHMS positionPrimary Winding 1Connect
the red tester lead to the yellowblue wire; connect the black tester lead to ground2With the shifter in the fourth gear position,
the meter must show less than ohmFIFTH GEAR 1Connect the red tester lead to the greenblue wire; connect the black tester
lead to ground2With the shifter in the fifth gear position, the meter must show less than ohmNOTE: If any of the above tests
show more than ohm, the switchharness andor the connectors must be replaced 1Connect the red tester lead to the terminal
(with the wire removed); connect the black tester lead to groundFig5-17 250300 cc Ignition CoilMagneto On the 250300 cc,