2000 Arctic Cat ATV Factory Service Manual, Page 220Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 220

1Remove the three machine screws and key cover securing the instrument pod2Remove the light bar from the instrument pod;
wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the temperature terminal
on the indicator light connector3The water temperature warning indicator light should illuminateNEUTRAL POSITION LIGHT 1Set
the meter selector to the D.CVoltage position2Connect the red tester lead to the yellow wire; connect the black tester lead
to the black wire3The meter must show battery voltageNOTE: The meter may show less than 12 volts due to the draw from the
headlightsOIL TEMPERATURE LIGHT VOLTAGE (300 cc) NOTE: The ignition switch must be in the ON position, and the test must
be performed on the lower side of the switch 1Connect the jumper positive wire to the power source terminal on the indicator
light connector2Connect the jumper ground wire to the neutral terminal on the indicator light connector3The neutral position
indicator light should illuminateREVERSE POSITION LIGHT 1Set the meter selector to the D.CVoltage position2Disconnect the