2000 Arctic Cat ATV Factory Service Manual, Page 221Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 221

3Connect the red tester lead to the redblack wire from the fan temperature switch; connect the black tester lead to the violet
lead to the red wire; connect the black tester lead to the gray wire9The meter must show less than ohm10With the switch in
the OFF position, connect the red tester lead to the red wire and the black tester lead to each of the remaining wires (orange
and gray)The meter must show an open circuit on both wiresNOTE: If the meter shows more than ohm of istanceroubleshoot or
replace the switchcomponent, the connector, or the switch wiring harness 1Set the meter selector to the D.CVoltage position2Connect
the red tester lead to the redblack wire; connect the black tester lead to the bluewhite wire3The meter must show battery
voltageREVERSE POSITION VOLTAGE NOTE: The ignition switch must be in the ON positionAlso, the reverse lever must be in the
REVERSE position, and the test must be performed on the lower side of the connector 1Set the meter selector to the D.CVoltage