2000 Arctic Cat ATV Factory Service Manual, Page 222Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 222

RESISTANCE (HI Beam) 1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; connect
the LO position, the meter must show an open circuitNOTE: If the meter reads resistance, troubleshoot or replace the switchcomponent,
the connector, or the switch wiring harnessRESISTANCE (Starter Button) ! CAUTION Do not run the engine at high RPM for more
than 10 secondsNOTE: If voltage is lower than specified, test charging coilsno loadVOLTAGE (Charging CoilsNo Load) 1Set the
meter selector to the Diode position2Connect the red tester lead to the orangewhite wire; connect the black tester lead to
the yellowgreen wire3With the starter button depressed, the meter must show 0.50.7 ohm4With the starter button released,
the meter must show an open circuit5Connect the red tester lead to the yellowgreen wire; connect the black tester lead to
the orangewhite wire6With the starter button depressed, the meter must show an open circuitNOTE: If the meter does not show