2000 Arctic Cat ATV Factory Service Manual, Page 223Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 223

! CAUTION Do not run the engine at high RPM for more than 10 secondsNOTE: If both charging coil tests failed, check all connections,
test between the three yellow wires (250300 cc) or the three black wires (400500 cc) for total of three testsFig5-24 1Disconnect
the battery ! WARNING Always disconnect the negative battery cable from the battery first; then disconnect the positive cable
2Remove the nut securing the positive cable to the starter; then remove the cable from the starterFig5-25 250300 cc 3In all
tests, the meter must show 0.11.0 ohmRESISTANCE (Trigger Coil) ! CAUTION Always disconnect the battery when performing resistance
tests to avoid damaging the multimeterFig5-26 400500 cc 1Set the meter selector to the OHMS position2On the 250300 cc, connect
the red tester lead to the blackyellow wire; connect the black tester lead to the greenwhite wireThe meter must show 90-140