2000 Arctic Cat ATV Factory Service Manual, Page 225Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 225

CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
measure the length of the brushesIf brush measurement is less than mm (0.40 in, replace with new brushes and brush springs
as set4Inspect the brush leads for cracks, wear, or frayingIf any of these conditions exist, replace with new brushes and
brush springs as set5Inspect the rear cover bushing for wear6Inspect the front cover bearing for wear 11Remove the positive
brush assembly from the starter housing 7Inspect the brass commutator end of the armature for any burned spots or damageIf
the commutator is lightly burned or damaged, the armature must be replacedThis is molded commutator and turning it down in