2000 Arctic Cat ATV Factory Service Manual, Page 228Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 228

6In order, install the thick metal washer, thin metal washer, and the fiber washer on the armature shaft; then install the
to the O-ring seal on the starter; then install the starter into the crankcaseSecure with two cap screws and wiring forms11Secure
the positive cable to the starter with the nut12Connect the batteryTESTING VOLTAGE Perform this test on the starter motor
positive terminalTo access the terminal, slide the boot awayNOTE: The ignition switch must be in the ON position, the emergency