2000 Arctic Cat ATV Factory Service Manual, Page 230Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 230

NOTE: If the meter shows no resistance, the relay is out of tolerance or it must be replaced 6With the 12-volt power supply
RESISTANCE ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Disconnect
the battery; then verify that the starter relay 30-amp fuse is good2Set the meter selector to the OHMS position3Connect the
red tester lead to terminal #1; connect the black tester to terminal #24The meter must show an open circuitNOTE: Leave the
tester leads connected to the terminals for the following procedureNOTE: An external 12-volt power supply "jumper" (positive
and negative connections) must be used for this testAlso, it is very important that the meter leads and power supply connections
are made to the appropriate terminals of the relay or damage to the multimeter will result ! CAUTION Always disconnect the
battery when performing resistance tests to avoid damaging the multimeter 1Set the meter selector to the OHMS position2Test