2000 Arctic Cat ATV Factory Service Manual, Page 235Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 235

2Connect the red tester lead to the white wire; connect the black tester lead to the black wire3With the dimmer switch in
must show battery voltageNOTE: If the meter shows no voltage, inspect bulb, fuses, wiring harness, connectors, and switches
TaillightBrakelight The connector is the 3-prong one located under the rear fender assemblyBULB VERIFICATION NOTE: Perform
this test on the taillight-brakelight side of the connectorAlso, 12-volt external power supply (jumper) will be needed Ignition
Timing The ignition timing cannot be adjusted; however, verifying ignition timing can aid in troubleshooting other componentsTo
verify engine timing, use the following procedure1Attach the engine Timing Light (pn 0644-197) to the spark plug high tension
lead; then remove the timing inspection plug from the left-side crankcase cover2With the Arctic Cat Engine Tachometer (pn
0644-275) connected, start the engine and run at 1800 RPM and then at 3800 RPM3I gnit ion ti mi ng should be according to