2000 Arctic Cat ATV Factory Service Manual, Page 255Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 255

BMeasure the flattened portion of the solderMeasurement must be between 0.05-0.10 mm (0.002-0.004 inFig6-73 6Measure gear
(16.5-22 ft-lb)Fig6-75 NOTE: If the measurem ent is not within specification, the right-side gear must be shimmedNOTE: To
determine which shim to use, measure the existing shim thickness; then using the existing shim as guide, adjust backlash
by referring to the Shim Chart SHIM CHART pn 3423-294 3423-295 3423-296 Thickness 0.8 mm0.0315 in 1.0 mm (0.0394 in 1.2 mm
(0.0472 in 5Position the shims on the left-side gear; then install the left-side gear into the hubPlace the hub assembly