2000 Arctic Cat ATV Factory Service Manual, Page 262Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 262

EMaximum runout must be within range of 0.00-0.05 mm (0.00-0.002 inNOTE: If the backlash range is not within tolerance, remove
of suitable straightedge; then record the width measurementFig6-116 43Check driven bevel geardriven output shaft bearing
clearance using the following procedureAMeasure the width of suitable straightedge; then record the width measurementFig6-113
FUsing calipers, measure the height from the straightedge to the driven shaft output bearing raceAF873D Fig6-117 BUsing calipers,