2000 Arctic Cat ATV Factory Service Manual, Page 263Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 263

HSubtract the driven ouput shaft bearing race height from the driven ouput shaft bearing housing cover height; then record
dye to several teeth of the gearCRotate the gear several revolutions in both directionsDExamine the tooth contact pattern
in the dye and compare the pattern to the illustrationsFig6-118 ATV-0104 NOTE: If tooth contact pattern is comparable to
the correct pattern illustration, no correction is necessary Tooth Contact Contacts at Top Contact at Root Shim Correction
Decrease Shim Thickness Increase Shim Thickness EIf tooth contact pattern is comparable to an incorrect pattern illustration,
shim the drive bevel gear housing assembly according to the chartFig6-121 ATV-0103 Fig6-119 45Place the appropriate shim
on the driven bevel gear, place the driven output shaft through the dog and into the differential cover, and place the washer