2000 Arctic Cat ATV Factory Service Manual, Page 270Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 270

Fig6-154 4Loosen the two cap screws securing the hydraulic brake caliper to the housing bracket; then remove the caliper
from the axle housingsAccount for inserts and sleevesFig6-157 1Place the ATV on support stand (positioned just in front of
and behind the footrest on each side) so the wheels are off the floor ! WARNING Make sure the ATV is solidly supported on
the support stand to avoid injury 2Remove the rear wheelsFig6-155 6Remove the four cap screws and three hex nuts securing
the rear of the swing arms to the axle housings and case 3Remove the clip securing the mechanical brake cable to the cable
guide; then loosen the socket-head cap screws securing the mechanical brake caliper to the brake discRemove the caliper from