2000 Arctic Cat ATV Factory Service Manual, Page 272Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 272

Fig6-163 5Inspect housing mounting bosses for wear or elongated holes6Inspect the frame welds for cracking or bending7Inspect
housing; then remove the axlesFig6-165 2Install the axles into the housing and install the hub bearings, C-clips, and sealsFig6-167
AF704D AF704D CLEANING AND INSPECTING 3Place new gasket on each side of the axle housings and place the housings into position;
then secure the axle housings to the case with cap screwsNOTE: The left-side axle housing mm stud must be coated with blue
Loctite #242 and the nuts tightened to 1.4 kg-m (10 ft-lb)The mm cap screws should be tightened to 2.8 kg-m (20 ft-lb)The
right-side axle housing three short 10 mm cap screws should be tightened to 4.8 kg-m (35 ft-lb), and the remaining long 10