2000 Arctic Cat ATV Factory Service Manual, Page 273Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 273

Fig6-168 Fig6-171 Fig6-169 6Place the gear case panel into position and secure with the cap screws and washersTighten the
to 10.4 kg-m (75 ft-lb)Fig6-170 NOTE: Note the position of the shoulder washer from disassemblyINSTALLING 1Maneuver the axle
assembly forward making sure propeller shaft splines engage properly and the final drive boot is positioned over the drive
housing2Place the rear of the swing arms into position on the axle housings and case; then secure with four cap screws and