2000 Arctic Cat ATV Factory Service Manual, Page 281Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 281

! WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the two cap screws and nuts
support stands are necessary to support the rear axle when the shock absorbers are removed or damage may occur 3Remove the
two cap screws and nuts securing each rear shock absorber to the frame and rear suspensionAccount for bushings and sleeves
from eachFig7-6 1Place the shock absorber spring over the shock absorber, compress the spring, and install the retainer2Place
bushings and sleeves (where appropriate) into shock eyelet; then install shock with two cap screws and nutsTighten all nuts
to 4.8 kg-m (35 ft-lb) ! CAUTION Do not tighten the nuts beyond the 4.8 kg-m (35 ft-lb) specification or the shock eyelet