2000 Arctic Cat ATV Factory Service Manual, Page 282Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 282

INSTALLING Swing Arms (400500 cc Models) REMOVING 1Remove the cap screws and hex nuts securing the front of the swing arms
drive caseRemove the hose grommets from the hose guides4Remove the swing arms and note the location of the hose guides on
the inner swing arm (for assembly)CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in
any way, replacement is necessary 2On the right side, place the outer swing arm into position and secure to the axle housing
with cap screw and hex nutDo not tighten at this time3Secure the two right side swing arms to the frame brackets with cap
screws and hex nutsDo not tighten at this time4On the left side, secure the swing arms to the axle housing and frame brackets