2000 Arctic Cat ATV Factory Service Manual, Page 293Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 293

6Place the bearing flange into position on the support bracketSecure with the cap screwsFig8-17 9Connect the fuel hose to
7Insert each tie rod end into the actuator arm; then install the slotted nut and tighten to 4.2 kg-m (30 ft-lb)Lock the nuts
with the cotter pinsFig8-18 1Inspect the grip for wear, cuts, or cracks2Inspect the grip for deteriorationINSTALLING NOTE:
Before installing grip, use contact spray or alcohol to clean the inside of the grip and the handlebar of glue residue, oil,
or any other contaminant 8Place the gas tank (accounting for spacers) into positionSecure with screws and washers 1Apply
liberal amount of Handlebar Grip Adhesive (pn 0636-071) to the inside of the grip2Align the rivet hole in the grip with the