2000 Arctic Cat ATV Factory Service Manual, Page 306Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 306

Rear Rack Fig8-76 Fig8-77 Rear Fender 250300 cc KEY 1Rear Rack 2Tube Wrap 3Reflector 4Cap Screw 5Retaining Clip 733-780C
with parts-cleaning solvent2Inspect all welds for cracking or bending3Inspect threaded areas of all mounting bosses for stripping4Inspect
for missing decals andor reflectorsINSTALLING REMOVING KEY 1Fender Panel 2Machine Screw 3Washer 4Machine Screw 5Expansion
Nut 733-395C 1Place the rack into position on the frame; then install the cap screws and any washers2Tighten the three mm
machine screws to 1.7 kg-m (12 ft-lb)3Tighten the four 10 mm cap screws to 5.5 kg-m (40 ft-lb) 1Remove the seat (see Seat
in this section)2Remove the rear rack (see Rear Rack in this section)3Remove side panels (see Front FenderSide Panels in