2000 Arctic Cat ATV Factory Service Manual, Page 307Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 307

CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
hold-down bracket on the 400500 cc models)2Tighten the cap screws to 5.5 kg-m (40 ft-lb)3Route the taillight wiring harness
over the rear frame; then connect the three-prong connector4Install the side panels (see Front FenderSide Panels in this
section)5Install the rear rack (see Rear Rack in this section)6Install the seat (see Seat in this section)ATV-0070 7Adjust
each headlight until correct aim is obtainedAHorizontal Loosen the nut beneath the headlight mounting grommet; then adjust
for proper aimingTighten the nut to 1.7 kg-m (12 ft-lb)BVertical Loosen the nut on the side of the headlight housing; then
adjust for proper aimingTighten the nut securely Adjusting Headlight The headlights can be adjusted vertically and horizontallyThe
geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming1Position the ATV on level floor
so the headlights are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)NOTE: There should