2000 Arctic Cat ATV Factory Service Manual, Page 316Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 316

AF715DA 4Remove the E-ring and pin securing the reverse cable to the reverse actuator arm; then loosen the jam nut securing
cable through the appropriate wire forms and secure with cable ties 3Place each end of the reverse cable into the frame mounts
and secure with the jam nuts 4Insert the upper end of the reverse cable into the hole in the reverse lever and secure with
an E-ringFig9-32 1Slide the reverse shift axle into the reverse shift leverWith an O-ring on the reverse shift axle, secure
the reverse lever to the reverse lever bracket with the reverse shift axleFig9-30 AF714DA 5Install the reverse lever over-center