2000 Arctic Cat ATV Factory Service Manual, Page 317Get this manual

2000 Arctic Cat ATV Factory Service Manual, Page 317

6Place the loop on the lower end of the reverse cable into the slot in the reverse actuator armSecure the cable to the actuator
until the actuator slides freely onto the shift shaft5Tighten the jam nut securing the reverse cable housing to the frameSecure
the reverse actuator to the shift shaft with the cap screwFig9-37 1Remove the cap screw securing the reverse actuator arm
to the reverse shift shaft; then slide the arm off the reverse shift shaftFig9-34 2Loosen the jam nut securing the upper
end of the reverse cable to the frame; then adjust the cable housing until the reverse indicator switch is fully depressedFig9-35