2001 Arctic Cat ATVs factory service and repair manual, Page 36Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 36

733-441A ATV-0074 4Remove the oil filter plug from the filter mounting boss (located on the front-right side of the transmission
(16 ft-lb)Pour 3.4 (3.5 U.Sqt) of the recommended oil in the filler hole To check the oil strainer, use the following procedure1Remove
the skid plate2Remove the cap screws securing the oil strainer cap; then remove the capAccount for the O-ringFig2-69 ! CAUTION
Any oil used in place of the recommended oil could cause serious engine damageDo not use oils which contain graphite or molybdenum
additivesThese oils can adversely affect clutch operationAlso, not recommended are racing, vegetable, non-detergent, and
castor-based oils 9Start the engine (while the ATV is outside on level ground) and allow it to idle for few minutes10Turn