2001 Arctic Cat ATVs factory service and repair manual, Page 41Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 41

NutsCap Screws Tighten all nuts and cap screwsMake sure rivets holding components together are tightReplace all loose rivetsCare
BTDCIGNITION TIMING MODEL 250 cc 300 cc 400500 cc TIMINGRPM BTDC below 1800 35 BTDC above 3800 BTDC 1800 30 BTDC 3800 10
BTDC 1500 To replace the headlight bulb, use the following procedure ! CAUTION The bulb portion of the headlight is fragileHANDLE
WITH CAREWhen replacing the headlight bulb, do not touch the glass portion of the bulbIf the glass is touched, it must be
cleaned with dry cloth before installing 1Remove the machine screw from beneath the headlight housing; then remove the lens
coverNOTE: It may be necessary to carefully pull certain amount of wiring harness slack through the housing for socket removal
2Push in on the wiring harness socket and turn it counterclockwise to free the bulb; then remove the bulb3Place the new bulb
into position making sure the tab on the bulb base aligns with the recess in the housing4Install the wiring harness socket