2001 Arctic Cat ATVs factory service and repair manual, Page 42Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 42

3Install the new bulb by turning it clockwise while pushing in4Install the lens cover AHorizontal Loosen the nut beneath
aiming surface (wall or similar aiming surface)NOTE: There should be an average operating load on the ATV when adjusting
the headlight aim 2Measure the distance from the floor to the mid-point of each headlight3Using the measurements obtained
in step 2, make horizontal marks on the aiming surface4Make vertical marks which intersect the horizontal marks on the aiming
surface directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe
each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below the horizontal
mark on the aiming surfaceFig2-84 Adjusting Reverse Shift Lever (Manual Transmission) ATV-0091 To shift into reverse gear,
stop the ATV completely and shift the transmission into neutralPull the reverse shift lever fully rearwardWhen the ATV is
in reverse gear, the gearshift pedal will not function and the reverse gear indicator light should be illuminated ! WARNING